USB connection: Connect the cable to the USB port on the rear of the printer and to a port on the Mac. At the printer port, the green light should be steady and the orange Wired (Ethernet) network connection: Connect the network cable to the printer Ethernet port and to an available port on the router or access point.
The blue bar stops flashing when the connection completes. Within two minutes, press and hold the WPS button on the router until the connection process begins. Wi-Fi connection for HP DeskJet 60, ENVY 60, and Tango printers: Press and hold the Wi-Fi button and the Power button on the back of the printer for five seconds until the blue bar flashes. The printer wireless light stops flashing Within two minutes, press and hold the WPS (Wi-Fi Protected Setup) button on the router until the connection process begins. Wi-Fi connection for most printers without a touchscreen control panel: Press and hold the Wireless button for five seconds or until the wireless light starts to flash. Wi-Fi connection for printers with a touchscreen control panel: Open the Setup, Network, or Wireless settings menu, select Wireless Setup Wizard, and then follow the instructions to select the network name and enter the password. Tick the 'Checked and confirmed' box and click 'Next' to proceed to the next step.Connect the printer to the same network that the Mac is connected to, or use a direct USB connection. Your devices operating system should already be selected upon arriving at the setup wizard portal. Run the setup wizard, selecting 'Yes' to the question that asks if you have a USB cable and press 'Next' to continue through the setup process. If you need wifi to start, connect to the UMASS network. Scroll to the end of this page and below the 'Utilities' section, select the 'Wireless Device Setup Wizard'.īefore running the setup wizard, please ensure your printer is connected to power, the USB cable is connected from the printer to the device that will be running the wizard, and the printer is turned ON. If the desired access point does not appear, go to 'Manual SSID Setup'. Tap Down until the desired access point appears, and then select the access point. Select your country/region and click on ' Product Search'.Įnter the printer model QL-810W and click 'Search'.Ĭlick on the Downloads option, this will automatically select your OS, change this to macOS 10.15x to ensure the wireless setup wizard is available to install. The printer automatically searches the access points on wireless network. Navigate to the Brother support website here. How to connect the Brother QL-810W label printer to the Wi-Fi network How to connect my Brother QL-810W to Wi-Fi (Mac) This article will take you through the steps to connect the Brother QL-810W label printer to the Wi-Fi network.įirstly, please ensure you have the printer USB cable on hand to connect to the Wi-Fi network using this method.
0 kommentar(er)
